O FAQtos está em curso no INOV-INESC, tendo como objectivo disponibilizar publicamente informação relevante sobre radiação electromagnética em comunicações móveis (...)

Equipamentos de medida

Título	An Automated SAR Measurement System for Compliance Testing of Personal Wireless Devices
Resumo	An automated specific absorption rate (SAR) measurement system has been developed for compliance testing of personal wireless devices. Unlike other systems, this system uses a model with a lossy ear-shaped protrusion and the accuracy of this experimental setup has been checked by comparing the peak 1-g SAR’s for ten cellular telephones, five each at 835 and 1900 MHz, with the results obtained using a 15-tissue anatomically based model with the finite-difference time-domain (FDTD) numerical electromagnetic technique. The SAR measurement system uses a three-dimensional (3-D) stepper motor to move a Narda Model 8021 E-field probe to measure the SAR distribution inside a headshaped tissue-simulant phantom near the radiating device. The head and neck part of the model with an ear-shaped protrusion of 3 mm thickness is made of a lossy outer shell of 5–7 mm thickness of epoxy laced with KCl solution. The phantom is filled with appropriate frequency-specific fluids with measured electrical properties (dielectric constant and conductivity) that are close to the average for gray and white matters of the brain at the center frequencies of interest (835 and 1900 MHz). The implantable E-field probe is calibrated using the FDTD calculated SAR variations for a slab model at two commonly used frequencies, 835 and 1900 MHz and is checked to have good isotropic characteristics (+/- 0.23 dB) and a wide dynamic range (0.01–10 W/kg). The system is validated using a 223 mm diameter sphere model. Peak 1-g SAR’s for ten telephones using different antennas are within +/-1 dB of those obtained using the FDTD numerical method for the anatomical model of the head and neck region.
Fonte	IEEE Transaction on Electromagnetic Compatibility
Origem	Internacional
Autor/Editor	Qishan Yu, Om P. Gandhi, Magnus Aronsson, and Ding Wu
Disponibilidade	Disponível por encomenda
Link	ieeexplore.ieee.org
Referência	vol. 41, no. 3, pp. 234-245
Data	Agosto 1999

Título	Automated E-field Scanning System for Dosimetric Assessments
Resumo	The interest in accurate dosimetric measurements inside phantoms that simulate biological bodies has burgeoned since several regulatory commissions began calling for or recommending the testing for compliance with safety standards of low power devices. This paper presents a newly developed, robot-based system that allows automated E-field scanning in tissue simulating solutions. The distinguishing characteristics of the system are its high sensitivity and its broad dynamic range (1 uW/g to 100 mW/g) over the entire frequency range (10 MHz to over 3 GHz) used for mobile communications. The reproducibility of the dosimetric evaluations has been shown to be considerably better than +/- 5%. This has been accomplished by the use of an improved isotropic E-field probe connected to amplifiers with extremely low noise and drift characteristics in conjunction with digital processing of data. Special emphazis has been placed on system reliability, user-friendliness and graphic visualization of data.
Fonte	IEEE Transactions on Microwave Theory and Techniques
Origem	Internacional
Autor/Editor	Thomas Schmid, Oliver Egger, Niels Kuster
Disponibilidade	Disponível por encomenda
Link	ieeexplore.ieee.org
Referência	vol. 44, no. 1, pp. 105-113
Data	Janeiro 1996

Título	Guide to the Expression of Uncertainty in Measurements
Resumo	When reporting the result of a measurement of a physical quantity, some quantitative indication of the result has to be given to assess its reliability and to allow comparisons to be made. The Guide to the expression of uncertainty in measurement establishes general rules for evaluating and expressing uncertainty in measurement that can be followed at many levels of accuracy and in many fields.
Fonte	International Electrotechnical Commission (IEC) / International Organization for Standardization (isso)
Origem	Internacional
Autor/Editor	ISO/IEC
Disponibilidade	Disponível por encomenda
Link	iso.org
Referência	ISO/IEC Guide 98-3:2008
Data	Outubro 2008

Título	Human exposure to radio frequency fields from hand-held and body-mounted wireless communication devices - Human models, instrumentation, and procedures - Part 1: Procedure to determine the specific absorption rate (SAR) for hand-held devices used in close proximity to the ear (frequency range of 300 MHz to 3 GHz)
Resumo	This basic standard applies to any electromagnetic field (EM) transmitting devices to be used with the radiating part of the equipment in close proximity to the human ear including mobile phones, cordless phones, etc. The frequency range is 300 MHz to 3 GHz. The objective of the standard is to specify the method for demonstration of compliance with the specific absorption rate (SAR) limits for such equipment.
Fonte	European Committee for Electrotechnical Standardization (CENELEC)
Origem	Internacional
Autor/Editor	Technical Committee 106X
Disponibilidade	Disponível por encomenda
Link	cenelec.eu
Referência	EN 62209-1:2006
Data	Julho 2001

Título	IEEE Recommended Practice for Determining the Peak Spatial-Average Specific Absorption Rate (SAR) in the Human Head from Wireless Communications Devices: Measurement Techniques
Resumo	IEEE Std 1528-2003 specifies protocols and test procedures for the measurement of the peak spatial-average SAR induced inside a simplified model of the head of users of certain handheld radio transceivers. These transceivers are intended to be used for personal wireless communications services, operate in the 300 MHz-3 GHz frequency range, and are intended to be operated while held against the ear. The results obtained by following the protocols specified in this recommended practice represent a conservative estimate of the peak spatial-average SAR induced in the head of a significant majority of persons, subject to measurement and other uncertainties that are defined in this standard. The results are representative of those expected during conditions of normal use of a handheld wireless device. It is not the intent of this recommended practice to provide a result representative of the absolute maximum SAR value possible under every conceivable combination of head size, head shape, handset orientation, and spacing relative to the head. The measurement of SAR induced in the external tissues of the head, e.g., the external ear (pinna), is not addressed in this standard. The following items are described in detail: measurement concepts, measurement techniques, instruments, calibration techniques, simulated-tissue (phantom) models, including homogeneous anatomical models of the human head and simple phantoms for validation of the SAR measurement system, and the limitations of these systems when used for measuring the spatial-peak mass-averaged SAR. Procedures for calibrating electric field (E-field) probes used for SAR measurements and assessing the SAR measurement and system uncertainties are provided in the annexes. This recommended practice is intended primarily for use by engineers and other specialists who are familiar with electromagnetic (EM) theory and measurement techniques. This standard does not recommend specific SAR limit values since these are found in other documents. The benefits to the users include standardized and accepted protocols, validation techniques, and means for estimating the overall uncertainty in order to produce valid and repeatable data.
Fonte	Institute of Electrical and Electronics Engineers (IEEE) Standards Coordinating Committee 34 (SCC 34)
Origem	Estados Unidos da América
Autor/Editor	IEEE - SCC 34
Disponibilidade	Disponível por encomenda
Link	ieeexplore.ieee.org
Referência	IEEE Std. 1528-2003
Data	Dezembro 2003

Título	OET Bulletin 65, Supplement C - Evaluating Compliance with FCC Guidelines for Human Exposure to Radiofrequency Electromagnetic Fields, Additional Information for Evaluating Compliance of Mobile and Portable Devices with FCC Limits for Human Exposure
Resumo	In August, 1996, the Commission adopted a Report and Order in ET Docket 93-62 amending its rules for evaluating the environmental effects of radiofrequency (RF) electromagnetic fields. Specifically, the Commission adopted new guidelines and procedures for evaluating human exposure to RF emissions from FCC-regulated transmitters and facilities. As a part of this proceeding, new limits were adopted for human exposure to RF emissions from certain mobile and portable devices. Two subsequent FCC Orders were issued to refine and clarify the decisions adopted in the original Report and Order. A revised version of OET Bulletin 65, "Evaluating Compliance with FCC Guidelines for Human Exposure to Radiofrequency Electromagnetic Fields" was also issued. One of the areas discussed in Bulletin 65 is compliance with the limits adopted by the Commission for safe exposure to RF emissions due to mobile and portable devices such as non-fixed wireless transmitters and hand-held cellular telephones. The first edition of Supplement C (97-01) was released in 1997. The purpose of this revised supplement is to provide parties filing applications for equipment authorization with guidance on complying with the latest requirements using up-to-date test procedures. This supplement is not intended, however, to establish mandatory procedures, and other methods and procedures may be acceptable if based on sound engineering practice.
Fonte	Federal Communications Commission (FCC)
Origem	Estados Unidos da América
Autor/Editor	David L. Means, Kwok W. Chan
Disponibilidade	Disponível online
Link	fcc.gov
Referência	OET Bulletin 65, Supplement C
Data	Junho 2001

destaques

08.08.2019

Novidades para breve....

O FAQtos deseja-vos boas férias…. mas fiquem atentos (…)

Ver mais

12.07.2019

Prémio FAQtos 2019: Resultados Finais

Podem consultar aqui o Resumo desta edição, com os (…)

Ver mais

10.07.2019

VENCEDORES dos 1º, 2º e 3º lugares no Prémio FAQtos 2019

(…)

Ver mais

faq's

glossário